Summry Assignment Example | Topics and Well Written Essays - 250 words

Summry - Assignment Example The front view is shown as full section. This kind of section is advantageous when the object is symmetrical about a centre line. Here, full section view may not be necessary. In this case, a half sectional view is drawn as a front view which shows internal details of half the component. In cases where full information cannot be obtained if the section is taken along the centre line, offset section is used. To obtain full details the cutting plane is offset by 90 degrees to pass through all the holes and slots. The advantage of this section lies where there are elongated parts of the object are also present. This is used to show the transverse section of one part of object. The cutting plane is shown in section by cutting in a direction perpendicular to the longitudinal axis. An adjacent view is obtained by rotating the cut section by 90 degrees. The Disadvantage of this kind of section is that when too many parts are present then using this section view may get complicated. In such cases, removed section proves to be advantageous as the section are shown removed from the front view located adjacently. This kind of sectional view has its own advantage as it does not use a cutting plane at all. Instead, the section view is shown with the front view and a jagged line is used to show the break. Hence, one may chose to break the object any way which helps showing the full internal details. The disadvantage of this view is that it may some how become difficult to decide how to introduce the break. In case, the object has elongated parts, the application of this section may become very